up 4.5 tire repair patch, - request. use with activator

up tire patches are used for the permanent repair of minor damage (e.g. nail damage) on passenger, truck and agricultural tires (both radial and diagonal, tubed and tubeless).
up patches do not these a sticking direction. they are intended for cold and hot vulcanization (for use in vulcanizing presses at a temperature of 85 ° c - 150 ° c).


fate

up 4.5 patch allows you to repair damage with a diameter of max. 4.5 mm in car and truck tires in the following range:

in the tread area of ​​radial and diagonal tires,
in the lateral zone of diagonal tires.


manual

apply an even layer of rema tip top special cement bl or fast dry cement bl to the roughened inner surface of the tire and wait until the solvent evaporates completely.
remove the protective film from the bond layer
focus up the patch on the affected area
roll the patch vigorously with a narrow pressure roller, moving from the center to the outer edges to avoid trapping air.
after removing the protective film of the patch, cover the roughened interior of the tire, which is not covered by the surface of the patch, with innerliner sealer.
follow the appropriate use and repair charts.
important:

always remember to seal the damage channel.
after repair and final inspection, the tire can be put into service immediately.
not suitable for repairing two-wheeled vehicles
the offer is 1 piece / 1 patch.

dimensions: 37x37 mm
storage conditions: 20 ± 5 °c, in a dry and dark place.
use only with special cement bl or fast dry cement bl
vulcanization temperature: 85stc - 150stc.

Delivery method