spary putty 1KG 2364+ hardener 30ML

description
sprayable polyester putty creates perfectly smooth surface also in big vertikaalsetel on surfaces. this teenindab min. after prior peale kantud putty töötlemist caused scratches for filling. requires lahjendamist.

high-quality 2-Component sprayable finishing putty, which is intended for a car repair.

easy taotlemisprotsess.
short kõvenemisaeg.
this isoleerib very well primer- and pealisvärvid täitepahteldest.
Substraadid
product indicates very good adhesion different type surfaces. it can implement:

steel and aluminium after matitamist and rasvaeemaldust.
in good condition grinded Polyester-klaaslaminaadid (GFK / GRP), polüesterpahtlid, acrylic- and epoksiidkrundid and old pinnakatted.
attention:
don't Apply polüesterpahtleid straight reaktiivkruntvärvidele, 1-komponentsetele acrylic- and nitrotselluloostoodetele.

Taotlusprotsess

application
small scratches for filling in car repair.
Polüesterpahtlitest akrüülkatete isoleerimiseks.

Segamissuhe mahu Follow
Putty: 100
hardener: 4,5
solvent max 10%

mix carefully, up to saadakse homogeenne Consistency.

sprayer viscosity
50 (+/- 5) seconds 20 °C at

mixture Serviceable life
20 (+/- 3) minutes 20 °C at.

layers number
1 ÷ 3 layers
gun parameetrid
head: 2,0 ÷ 3,0 mm
pressure: according to Device manufacturer soovitustele, usually 2,0 ÷ 2,5 baari.
cover thickness
one märja layer thickness not allowed ületada 200 µm.
Kogupaksus not allowed ületada 600 µm.


Aurustumise time
layers vahel: ca 5 minutes
before küpsetamist: approximately 10 minutes

evaporation time depends temperature and layer thickness.

Kõvenemise time
2-3 hours at temperature 20 °C.
25-30 minutes at temperature 60 °C.

temperature alla 20 ° C prolongs significantly kõvenemisaega.


grinding
Viimistluslihvimine (dry): P180 ÷ P320.


IR kuivatamine
5–7 minutes lühilaineid, depending on layer thickness (up to 200 µm) and radiators tüübist.
don't exceed temperature 60 ° C.
use Device manufacturer soovituste kohaselt.
before infundeerimist wait approximately 5 minutes, et this dry.

playback
1 liitrist segust enough approximately 8 m2 surface for painting 100 µm thickness coating.


Edasine work
Pihustuspahtleid can apply:
- 2-component akrüülvundamendid.
- 2-component epoksükrundid.

Üldised mõtted
- excessive quantity hardener may cause stand-/pealisvärvi värvimuutusi! - minimum recommended Operating Temperature on + 15oC.
- 2-komponentsete toodetega working is recommended to use isikukaitsevahendeid. to protect to eyes and hingamisteid.
- Ruumid black be well ventileeritud.
- tools black pesta immediately after applying.

Note. safety to ensure järgige always Product ohutuskaardil olevaid instructions