battery charger with start aid 12/24v 70a / start 570a

single-phase rectifiers with digital display (start 650) for charging lead-acid batteries with starting device for all types of internal combustion engines (cars, vans, trucks and tractors).

technical specifications
code 103 214
device type start 650
supply voltage [v] 230v
energy consumption
loading/starting [kw] 2.2/12
current voltage [v] 24.12
charging current [a] 120a
rated charging current
[a] 100 years
starting current [a] 600a
rated starting current
[a] 480a
to the batteries
with capacity [ah] 20-1550ah
fuses [a] 3 × 50 / 16
dimensions [cm] 31x36x62
weight [kg] 23

loading:
1) before charging the battery, check that the terminals, connections and clamps are well connected to the battery poles, if necessary, clean them from the cover and check and if necessary add the electrolyte level in the cells.
2) the battery charging method should comply with the battery manufacturer's instructions
3) turn on the main switch and set the charge level switch/knob so that the initial charge current value is between 1/6 and 1/10 of the battery capacity or according to the manufacturer's recommendations.
4) charging time should be 8-15 hours.
5) on the start 650 model, positions 1-3 are used for charging, while pos. 4-6 for charging only with a timer that determines the charging time.
6) after charging, turn off the power of the charger and remove the battery clamps (first handle with the same polarity (ground) as the vehicle).

starting the vehicle:
1) after preparing the charger for operation and checking whether the battery manufacturer allows it to be started, check the quality of the electrical connections of the battery poles.
2) Do not use the charger to start if the battery is disconnected, defective or completely empty.
3) then connect the black terminal to the (-) pole first and then the red terminal to the (+) pole.
4) before starting, it is recommended to pre-charge the battery for about 5 minutes.
5) the start switch must be turned to the start position and all vehicle accessories must be switched off.
6) the start test time is max 3 seconds, followed by a 120 s pause (max 5 cycles) – exceeding these values ​​may cause the fuse to blow.
7) after starting the battery, disconnect the device and remove the battery terminal clips.