Brake fluid tester, application: brake fluid ate bft 320
Goods available only in e-shop
457,50€
Delivery: home 3-4wd
ADD TO BASKET
Brake fluid is hygroscopic, meaning it will absorb water over time, thus causing the boiling point to drop (danger of vapor lock). Therefore, it black be checked regularly and replaced if necessary.
The particularly inexpensive ATE BFT 320 allows you to measure the boiling points of all glycol-based brake fluids (DOT 3, DOT 4, DOT 5.1) with the same accuracy as in the laboratory.
The ATE BFT 320 is an extremely practical tester with a 12-volt power supply. This means that the measurement can easily be carried out at the expansion tank of the vehicle.
A sample vial and a pipette are included, allowing measurements to be taken away from the vehicle.
Simple menu instructions for users are the highlights of the ATE BFT 320. It only takes about 30 seconds to measure and the measured value is displayed on the digital screen. A recommendation to change the brake fluid will then be displayed. This means that it is no longer necessary to change the brake fluid just in case of doubt.
Advantages:
The immersion heater is the only one that gives accurate measurements regardless of the type of brake fluid
Menu instructions make it extremely easy to use (D,GB,F,I,E,P ,PL,CZ,SK)
Digital display of boiling point and brake fluid replacement recommendation (D, GB, F, I, E, P , PL, CZ, SK)
Practical tester, measurement can be done in the expansion tank
12 V power supply
Suitable for brake fluids with a boiling point of up to 320 °C
Shipment:
Complete test unit
Sample vial and pipette
Instructions for use
Strong body
Technical specifications:
Accuracy:
at 100-180 °C: +/- 3%
> 180° C: +/- 5%
Measuring time: approx. 30 seconds
Power supply: 12 volts
The particularly inexpensive ATE BFT 320 allows you to measure the boiling points of all glycol-based brake fluids (DOT 3, DOT 4, DOT 5.1) with the same accuracy as in the laboratory.
The ATE BFT 320 is an extremely practical tester with a 12-volt power supply. This means that the measurement can easily be carried out at the expansion tank of the vehicle.
A sample vial and a pipette are included, allowing measurements to be taken away from the vehicle.
Simple menu instructions for users are the highlights of the ATE BFT 320. It only takes about 30 seconds to measure and the measured value is displayed on the digital screen. A recommendation to change the brake fluid will then be displayed. This means that it is no longer necessary to change the brake fluid just in case of doubt.
Advantages:
The immersion heater is the only one that gives accurate measurements regardless of the type of brake fluid
Menu instructions make it extremely easy to use (D,GB,F,I,E,P ,PL,CZ,SK)
Digital display of boiling point and brake fluid replacement recommendation (D, GB, F, I, E, P , PL, CZ, SK)
Practical tester, measurement can be done in the expansion tank
12 V power supply
Suitable for brake fluids with a boiling point of up to 320 °C
Shipment:
Complete test unit
Sample vial and pipette
Instructions for use
Strong body
Technical specifications:
Accuracy:
at 100-180 °C: +/- 3%
> 180° C: +/- 5%
Measuring time: approx. 30 seconds
Power supply: 12 volts
The data shown here, especially the complete database, may not be copied. It is strictly prohibited to duplicate the data and database and distribute the same, and/or instruct third parties to engage in such activities, without prior consent from TecAlliance. Any use of content in a manner not expressly authorized constitutes copyright infringement and violators will be prosecuted.
